Well, friday night I took the 16G out, put in the Hoe HX35 and mocked up a jig to build a jig. Clearance is tight but tis going to be bad ass. Ordering two Tial MV-S gates, and talking to ETS about making me a collector. Took it out, and put in Wes's 5031 temporarily. So far its sounds bad ass because it doesnt have a divided turbine housing, and the dump is always open. It runs pretty good, no tune, but I haven't been able to turn to boost down below 35psi. I havent really looked into it, I'll check it out monday, for now, right foot boost control.

Here are some pics on the Ho mocked up.
Thanks Mr Gus for being the helping hand and holding that heavy bitch in place while it welded up the jig.

Fo sho Mr Sam, it will be a SICK setup once its done. Kind of getting me motivated to get started on my own project.

I have an evo 3 O2 housing if you want to borrow it to go with the 5031. Might keep the cops off your ass.

The Holset setup is looking sick. I can't wait to see how fast the spool is running it divided.