| Author |
Message |
|
hapa
DSM Regular
Joined: Mon Jun 21, 2010 1:41 pm Posts: 30 Location: S.G.V.
|
 problems....one after another!!!!
so i bought a 98 gst a week ago from an old buddy of mine. the car hasnt been driven in almost 4 years now.... so i has a few problems.
got the car home bought a new battery and put some gas in the car. and it took a few cranks but it started. it ran super rich and was drenching the plugs, so the car wouldnt rev. found that the coolant temp sensor was bad. changed that and i also changed to denso iridium plugs and the car started right up. revd up no problem but couldnt keep it running. now the car wont start. just cranks and cranks..... the car is getting spark but i still ordered magnacore wires and msd replacement coil. now im guessing it isnt getting fuel.... next is to check my pump. im also going to be change the fuel filter as well.
if anyone has any input on what they make think the problem is please feel free to chime in.
just trying to get the car running so i can take the car to get tuned!
|
| Tue Jun 22, 2010 8:09 pm |
|
 |
|
Synthetek
Luvz teh Beer!!
Joined: Tue May 22, 2007 6:46 pm Posts: 2848 Location: La Palma, OC
|
 Re: problems....one after another!!!!
Does it have stock injectors? fuel pump? Do you have dsmlink or SAFC or some other type of engine management? And get rid of the iridiums and get some NGK BPR7ES
_________________99 GSX - 296.5 AWHP
I'm assuming you all have guns and crack!
|
| Tue Jun 22, 2010 8:15 pm |
|
 |
|
fmedgsx
DSM Regular
Joined: Sun Dec 20, 2009 6:48 pm Posts: 267 Location: san diego the whales vagina
|
 Re: problems....one after another!!!!
well you said it had a maf-t in one of your other posts is it set properly for your setup meaning set to 450's with dsmlink or set to the proper sized injectors with a safc?
_________________ Kris Albee 1997 pearl grey gsx project Holly Wood 1991 tsi awd stock bottom end w/ 2g head, kiggly springs, HKS 272's, RC1200's, shep4, QM twin, fp manifold, full megan exhaust, hx35 in bep housing, ets 4" fmic, BJ'sSMIM, Tial bov, tial 41mm, v3 ecmlink SD, 30psi, E85, 99 problems and this Bitch is one
|
| Tue Jun 22, 2010 9:12 pm |
|
 |
|
hapa
DSM Regular
Joined: Mon Jun 21, 2010 1:41 pm Posts: 30 Location: S.G.V.
|
 Re: problems....one after another!!!!
|
| Tue Jun 22, 2010 9:53 pm |
|
 |
|
DSM99
Moderator
Joined: Fri May 25, 2007 11:51 am Posts: 3373 Location: The Bat-Cave
|
 Re: problems....one after another!!!!
belive me, listen to what people are telling you here. Go to an autoparts store or RRE and spend the 10bucks on the NGK BPR7ES plugs. Just because it worked on other cars doesn't mean it gonna work on this one. DSM's are REALLY picky. You have to learn on how to use the right combination of OEM and aftermarket parts.
|
| Tue Jun 22, 2010 9:58 pm |
|
 |
|
hapa
DSM Regular
Joined: Mon Jun 21, 2010 1:41 pm Posts: 30 Location: S.G.V.
|
 Re: problems....one after another!!!!
|
| Tue Jun 22, 2010 10:05 pm |
|
 |
|
fmedgsx
DSM Regular
Joined: Sun Dec 20, 2009 6:48 pm Posts: 267 Location: san diego the whales vagina
|
 Re: problems....one after another!!!!
I have no experience with that apexi thingy so my suggestions are limited
_________________ Kris Albee 1997 pearl grey gsx project Holly Wood 1991 tsi awd stock bottom end w/ 2g head, kiggly springs, HKS 272's, RC1200's, shep4, QM twin, fp manifold, full megan exhaust, hx35 in bep housing, ets 4" fmic, BJ'sSMIM, Tial bov, tial 41mm, v3 ecmlink SD, 30psi, E85, 99 problems and this Bitch is one
|
| Tue Jun 22, 2010 10:14 pm |
|
 |
|
Erix
Senior Member
Joined: Tue May 22, 2007 7:10 pm Posts: 4767 Location: 818
|
 Re: problems....one after another!!!!
_________________ Current: '97 GS-T Spyder Past: '90 2.0L GS Turbo, '98 GS-T Spyder, '90 1.8L GS
|
| Wed Jun 23, 2010 12:27 am |
|
 |
|
clockworktoy
Squish Face
Joined: Tue May 22, 2007 7:08 pm Posts: 4327 Location: LBC
|
 Re: problems....one after another!!!!
Don't just guess its not getting fuel, verify by removing the return line at the rail. If you are getting fuel and spark, then it would have something to do with the Power FC. I have limited experience with the apex unit so i don't have any comments about that in particular. You said you had a tuner, so im sure he can check that for your.
|
| Wed Jun 23, 2010 12:41 am |
|
 |
|
Synthetek
Luvz teh Beer!!
Joined: Tue May 22, 2007 6:46 pm Posts: 2848 Location: La Palma, OC
|
 Re: problems....one after another!!!!
_________________99 GSX - 296.5 AWHP
I'm assuming you all have guns and crack!
|
| Wed Jun 23, 2010 1:30 am |
|
 |
|
Illeagle
Talon of Doom
Joined: Wed May 23, 2007 10:07 am Posts: 3615 Location: Long Beach
|
 Re: problems....one after another!!!!
Get rid of the irridiums, go back to copper. I don't care what he/she said they car "Made", right now it probably isnt making 150whp. Also GT30R isnt going to make 430whp on pump gas, you'll have to run leaded fuel to get aggressive enough on the tune to make that number. If the PowerFC is running in D'Jetro mode right now, make sure that the MAP sensor isn't dead. If its still on the stock MAF setup, make sure it unit isn't set to D'Jetro or vice versa. Power FC doesn't reset itself on battery power loss, so whatever settings that was put in should still be there. I got money on that the plugs are fouled out again. Sorry but when you foul out a set of plugs, then swap in now ones, its only a matter of time till the new ones are fouled out if the car was rich enough to kill the first set of plugs. Magical unobatnium plugs isn't going to fix the fact that your tune is off. I build and tune DSMs for a living and I do it for a well known shop that is probably top 3 in the world when it comes to building DSMs and if you call or ask anyone here at RRE, we'll all tell you to get rid of those plugs. If you aren't going to accept the info the people have to give, don't ask for it. I'm giving you cold hard info, like it or not from and un-biased point of view. I'm not getting anything out of helping you. The guy who sold you the car in the other hand, will sing you a love song and make you breakfast in bed so you'd buy it, he's got something to gain. Dump off a dead project and make some cash.
_________________1/4 ET-11.657@121.18mph w/ 1.682 60' 445whp/427tq on RRE Dyno All on 91 pump. Do you need your car tooned? Got some extra cash? PM me for details. I offer street and dyno tunes
|
| Wed Jun 23, 2010 1:35 am |
|
 |
|
Black_gst
Death to Head Gaskets!
Joined: Tue Jan 27, 2009 10:38 am Posts: 1979
|
 Re: problems....one after another!!!!
just turn up the boost... thats why your running rich you need more boost. boost fixes everything.
and if your "tuner" is this "know it all" why bother asking us, we dont know shit right?
dont ask for help on a fourm and then try and tell us were wrong. those spark plugs you bought cost what $8 each? they are garbage, not worth the box they came in. NGK's are the best plug you can run, theres people making 600hp+ and they run the $2.50 ngk plug.
|
| Wed Jun 23, 2010 6:32 am |
|
 |
|
hapa
DSM Regular
Joined: Mon Jun 21, 2010 1:41 pm Posts: 30 Location: S.G.V.
|
 Re: problems....one after another!!!!
|
| Wed Jun 23, 2010 8:09 am |
|
 |
|
Black_gst
Death to Head Gaskets!
Joined: Tue Jan 27, 2009 10:38 am Posts: 1979
|
 Re: problems....one after another!!!!
Well if your going to take just one persons advice from this site listen to Illeagle he is likely the most experienced person on this site when it comes to DSMs he works for Road Race Eng
|
| Wed Jun 23, 2010 8:18 am |
|
 |
|
SOADweskey
No More 2.3L
Joined: Tue May 22, 2007 7:36 pm Posts: 4412 Location: Jacksonville, FL
|
 Re: problems....one after another!!!!
Illeagale said in his post that he works for RRE. And Cosworth isn't even a DSM shop as they only support Evo's and don't make a damn thing for DSMs anymore since they moved on to where the money is.
I've run super magical expensive plugs before in my GSX only to find that running high boost destroys them and they break up like crazy at the top end under boost while the bargain basement NGK's work just fine as long as I gap them right.
_________________ Boost Creep is your turbo's way of calling you a little bitch for not running enough boost.
452 AWHP 446 lb ft of torque e85 FTW!!
"They are cool manly men now those DSM owners. Before it was just pasty white nerds, metro hair Asian kids and fruit pickers. They do real car club stuff and everything. Sometimes they even spend money here :-/"
-Mike W
|
| Wed Jun 23, 2010 8:24 am |
|
|