| ladsm.com http://ladsm.com/forum/ |
|
| Clutch Hydraulics http://ladsm.com/forum/viewtopic.php?f=5&t=4697 |
Page 1 of 1 |
| Author: | RiG [ Fri Jul 25, 2008 2:59 pm ] |
| Post subject: | Clutch Hydraulics |
| Author: | BoostFrenzy [ Fri Jul 25, 2008 6:53 pm ] |
| Post subject: | |
If I remember correctly, launching on a high pressure PP will make both the master and the slave fail prematurely. |
|
| Author: | clockworktoy [ Sat Jul 26, 2008 1:11 am ] |
| Post subject: | |
Ive been in the same boat for the past two years or so. I found that pre loading the system with an extended slave rod it kills slaves like crazy (Yet still works like you probably already know). From my personal experiences shimming the pivot ball has worked the best for me (even with a new fork/ball). And next time my slave takes a crap im going to try to find one off a galant vr4 apparently they have a smaller bore so it will extend more without the need for an extended rod. I hope this is of some help, and i feel your pain. |
|
| Author: | turboawdfanatic [ Sat Jul 26, 2008 2:15 am ] |
| Post subject: | |
| Author: | RiG [ Mon Aug 11, 2008 3:40 pm ] |
| Post subject: | |
| Author: | clockworktoy [ Mon Aug 11, 2008 8:01 pm ] |
| Post subject: | |
| Author: | RiG [ Tue Aug 12, 2008 10:15 am ] |
| Post subject: | |
| Author: | turboawdfanatic [ Tue Aug 12, 2008 12:33 pm ] |
| Post subject: | |
| Author: | RiG [ Tue Aug 12, 2008 4:08 pm ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|