| ladsm.com http://ladsm.com/forum/ |
|
| BISS SCREW http://ladsm.com/forum/viewtopic.php?f=5&t=11860 |
Page 1 of 1 |
| Author: | Dloiphone [ Wed Sep 08, 2010 7:28 pm ] |
| Post subject: | BISS SCREW |
my biss screw is all worned out and stripped. anybody have had this problem, and have a suggestion to get it out? and where can i get a replacement for it as well? havent been able to find it |
|
| Author: | Illeagle [ Wed Sep 08, 2010 7:31 pm ] |
| Post subject: | Re: BISS SCREW |
OEM Mitsubishi MD614948 -Screw Itself MD608806 - O-ring for screw. Drill with easy out can get it out pretty easy. Oil the new o-ring up a little before installing it. It should be set about 2 full turns from soft bottom when you put the new one in. |
|
| Author: | Dloiphone [ Wed Sep 08, 2010 7:33 pm ] |
| Post subject: | Re: BISS SCREW |
DAMN!! that was quick sam. Thanks! In order to adjust the BISS screw do I really need a scan tool for this? I read some people just turn it while the car is idling but not sure if its a must to have though. |
|
| Author: | Illeagle [ Wed Sep 08, 2010 7:56 pm ] |
| Post subject: | Re: BISS SCREW |
No, the scan tool is to just lock the ISC to where you can adjust the BISS and the ISC wont compensate. But most cars after you get it down just right, its usually, 1.5~2 turns out from soft bottom. So with the car off, turn it all the way in till it stops, dont go really tight, just till it snuggly stops. Then turn it out 2 turns. Fire it up, let the car warm up and idle for like 5~7 minutes after its warm, its should be good. |
|
| Author: | Dloiphone [ Fri Sep 10, 2010 6:18 pm ] |
| Post subject: | Re: BISS SCREW |
after inspection, i noticed it does not have the BISS screw after all and it was filled in with something. i called rre and ask for you sam, but i was told by robert you were busy working on a car. He suggested to just buy a new throttle body |
|
| Author: | Wally [ Sat Sep 11, 2010 10:19 pm ] |
| Post subject: | Re: BISS SCREW |
| Author: | Dloiphone [ Sun Sep 12, 2010 10:53 am ] |
| Post subject: | Re: BISS SCREW |
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|