| ladsm.com http://ladsm.com/forum/ |
|
| is my headgasket okay? http://ladsm.com/forum/viewtopic.php?f=5&t=11586 |
Page 1 of 1 |
| Author: | TALONTED [ Thu Jul 15, 2010 11:20 pm ] |
| Post subject: | is my headgasket okay? |
i have a eagle talon, i love it but its giving me a problem im not sure how to solve. i love running my car, and with the mods ive done to it incuding fmic, 16g, boost controller; i have seemed to have possibly wounded my head gasket. the symptons are over heating and lack of power, but only after ive been running it for a while. and with only running 10 boost with some creep. could it possibly be the water pump? i already did the thermostat, and was told without the supporting mods ive wounded the gasket. best route i should go anyone? |
|
| Author: | Wally [ Fri Jul 16, 2010 8:24 am ] |
| Post subject: | Re: broken wing |
Run the car at idle without a radiator cap and see if you can see a constant flow of air bubbles . You can also do a compression test. I've been running the setup you have for a while no problems. I also have a fmic 15psi on a E3 16g and boost controller with no supporting mods. My car was overheating but that was because my head came lose and torqued it down problem went away. There's a few people on here that run the same setup with no supporting mods. I seriously thought this was going to be a thread on a broken wing lol. |
|
| Author: | turboawdfanatic [ Fri Jul 16, 2010 9:33 am ] |
| Post subject: | Re: is my headgasket okay? |
You should be perfectly safe only running 10-12psi, but that's not to say your head gasket is fine. Do the checks Wally recommended and search tuners for some more info on it. You can also take a sample of your coolant somewhere to get checked to see if it's been contaminated from a blown gasket. One check is to take off the rad cap, start the car and warm it up, then give it a little gas and see if coolant shoots out like a geyser. If it does, you have a leak from one of the cylinders into the cooling system. |
|
| Author: | Black_gst [ Fri Jul 16, 2010 9:40 am ] |
| Post subject: | Re: is my headgasket okay? |
i have a block tester that reads for Hc's in your coolant i dont know where you live but if you were close i could test it for a small fee lol ($10) it only takes like 10 mins. or you can get the tester from napa... they are like $60. |
|
| Author: | TALONTED [ Sun Jul 18, 2010 11:03 pm ] |
| Post subject: | Re: is my headgasket okay? |
thanks guys. well yeah, luckily i have one of those head gasket tester in my shop. ill give that a try, and get back to ya |
|
| Author: | ghetto_bird [ Mon Jul 19, 2010 11:27 am ] |
| Post subject: | Re: is my headgasket okay? |
Damn block tester, haven't used one of those bad boys in a while..... Good to hear you guys are diagnosing with the right tools.... |
|
| Author: | So_CalXDSM [ Fri Jul 23, 2010 2:20 pm ] |
| Post subject: | Re: is my headgasket okay? |
By your avatar it seems like you have a huge fmic, are you using the stock radiator? |
|
| Author: | wimploki [ Sun Jul 25, 2010 10:15 am ] |
| Post subject: | Re: is my headgasket okay? |
When was the last time you replaced your radiator cap? A bad radiator cap causes the engine to overheat. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|